UR 10e

##Location Main Lab, within green cage, ceiling mounted.

##Technical Details Maximum Payload: 12.5kg Reach: 1300mm Axis Data:

  • Axis 1: ±360°
  • Axis 2: ±360°
  • Axis 3: ±360°
  • Axis 4: ±360°
  • Axis 5: ±360°
  • Axis 6: ±360°

    Printing clay

Stoneflower Clay extruder technical specs

Setting up

Using the manual motor control

Cleaning up

  • After use, ensure that both the robot and extruder are turned off. For the extruder, please also disconnect the electronics box.
  • Always return the LAN cables to their proper place. Do not leave them on the floor, as this poses a tripping hazard and could damage the connectors on the robot or router.
  • If you plan to use the extruder consecutively, you may leave it loaded. However, cover the hole to prevent the clay from drying on the auger screw.
  • If you will not be using the extruder consecutively, please clean the extruder thoroughly and cover the hose to prevent clay from drying inside.
  • Ensure all working surfaces, including the floor around the area, are clean of any clay residue after use.